刘慧强,凤仪,张学斌,李斌,余东波,朱艳芳,刘晓燕

• 1:合肥工业大学材料科学与工程学院

摘要(Abstract)：

采用通孔泡沫铝作基体的"包壳密封法"制备高含量NaI的Al-NaI放射性嬗变靶材。分别在20、50和80℃的蒸馏水中对未烧结和烧结过的Al-NaI放射性嬗变靶材进行水化学稳定性试验。用AAS-800原子吸收光谱仪对浸出时间分别为24、48、72和96 h的浸出溶液进行浓度测量,从而计算出不同条件下各种嬗变靶材在蒸馏水中的浸出率。结果表明,烧结后的靶材浸出率不会超过10%,远远低于未烧结的靶材,满足NaI嬗变率测量的实验要求。

关键词(KeyWords)： 泡沫铝;Al-NaI靶材;水化学稳定性;浸出率

Abstract:

Keywords:

基金项目(Foundation): 国家高技术研究发展计划重点项目(2009AA050705)

作者(Author): 刘慧强,凤仪,张学斌,李斌,余东波,朱艳芳,刘晓燕

DOI: 10.13289/j.issn.1009-6264.2011.10.001

参考文献(References)：

• [1]Bowman C D.External neutron drive for subcritical reactors[J].Nuclear Science and Engineering,2009,161(1):125-129.
• [2]Ingelbrecht C,Lupo J.129I targets for studies of nuclear waste transmutation[J].Nuclear Instruments and Methods in Physics Research,2002,A480(1):204-208.
• [3]史永谦.核电站乏燃料对生物圈的影响及ADS对策[J].原子核物理评论,2007,24(2):151-155.SHI Yong-qian.Radiation effect of spent fuel of nuclear power on biological circle and ADS strategy[J].Nuclear Physics Review,2007,24(2):151-155.
• [4]Voronkov V A,Dyachenko V M,Kostin Vya.Neutron generation in extended lead targets using the synchrophasotron beams[J].Atomn Energia,1990,68:449-453.
• [5]Bowman C D,Arthur E D,Lisowski P W,et al.Nuclear energy generation and waste transmutation using an accelerator dirven intense thermal neutronsource[J].Nucl Instrum Methods,1992,A320:336-367.
• [6]Leray S.Nuclear waste transmutation[J].Nuclear Instruments and Methods in Physics Research,1996,113(1-4):495-500.
• [7]梁彤祥,唐春和,等.长寿命放射性废料的嬗变处理[J].核技术,2003,26(12):935–939.LING Tong-xiang,TANG Chun-he,et al.Transmutation of long-lived nuclides[J].Nuclear Techniques,2003,26(12):935–939.
• [8]Pagani C,Barni D,Bellomo G.Superconducting accelerators for nuclear waste transmutation[J].EEE Transactions on Applied Superconductivity,1999,9(2):869-872.
• [9]张玉山.长寿命核废物嬗变处理的研究综述[J].原子核物理评论,1997,14(4):251-258.ZHANG Yu-shan.Development aspects of long-lived radiowaste transmutation processing[J].Nuclear Physics Review,1997,14(4):251-258.
• [10]WAN J S,Ochs M,Brandt R,et al.Transmutation of radioactive waste by means of relativistic heavy ions[J].Kerntechnik,1998,63:167-177.
• [11]WAN J S,Schmidt T h,Langrock E J,et al.Transmutation of 129I and 237Np using spallation neutrons produced by 1.5,3.7 and 7.4 GeV protons[J].Nucl Instrum Methods,2001,A463(3):634-652.
• [12]Adam J,Katovsky K,Balabekyan A.Transmutation of 129I,237 Np,238 Pu,239 Pu,and 241Am using neutrons produced in target-blanket system energyplus transmutation by relativistic protons[J].Pramana-Journal of Physics,2007,68(2):201-212.
• [13]Yoshiro Shirasu,Kazuo Minato.Selection of chemical forms of iodine for transmutation of 129I[J].Journal of Nuclear Materials,2003,320:25-30.
• [14]凤仪,朱震刚,潘艺,等.应变速率对闭孔泡沫铝力学性能和能量吸收性能的影响[J].材料热处理学报,2004,25(2):68-72.FENG Yi,ZHU Zhen-gang,PAN Yi,et al.Influence of strain rate on the mechanical properties and energy absorption capacity of aluminum alloy foam[J].Transactions of Materials and Heat Treatment,2004,25(2):68-72.
• [15]程和法,胡孔刚,薛国宪,等.泡沫铝合金显微组织和压缩力学性能的研究[J].材料热处理学报,2005,26(4):60-64.CHENG He-fa,HU Kong-gang,XUE Guo-xian,et al.Study on microstructure and compressive mechanical propertiesof aluminum alloy foams[J].Transactions of Materials and Heat Treatment,2005,26(4):60-64.
• [16]张瑞珠,郭志猛.SrTiO3固化高放废物浸出性能[J].北京科技大学学报,2006,28(4):373-376.ZHANG Rui-zhu,GUO Zhi-meng.Leaching properties of HLW-SrTiO3 form[J].Journal of University of Science and Technology Beijing,2006,28(4):373-376.
• [17]黄培云.粉末冶金原理[M].北京:冶金工业出版社,1982:284-286.

文章评论(Comment)：