聂朝胤,安藤彰朗,潘婧,贾晓芳

• 1:西南大学材料科学与工程学院
• 2:等离子工学研究所

摘要(Abstract)：

采用电弧离子镀技术在不锈钢SUS440C基片上沉积了CrSiN薄膜,并在此基础上通过引入Cr应力缓和层制备了CrSiN/Cr多层薄膜,研究了Cr应力缓和层对缓解CrSiN薄膜内部应力、增强膜基结合力、提高薄膜沉积厚度的作用。利用X射线衍射仪及sin2ψ法测试计算了薄膜的内部应力、采用扫描电镜及透射电镜观察了薄膜的显微结构,采用微米划痕仪测试了膜基结合强度。结果表明:20～30 nm极薄Cr层的导入,缓解了CrSiN薄膜内部应力的积累,降低了薄膜整体的内部应力,选择合适的Cr层数,最大可降低内部应力1/2。CrSiN/Cr多层膜仍保持了原有的连续柱状晶生长模式,CrSiN层与Cr层间,界面完整清晰,Si-N非晶部分缓解了CrSiN中CrN晶格与Cr层中Cr晶格间的失配,使得层间结合紧密牢固。划痕仪测试结果表明膜基结合强度与薄膜内部应力呈现出高度的相关性,Cr应力缓和层的导入改善了薄膜的膜基结合力、提高了薄膜可沉积厚度。

关键词(KeyWords)： 电弧离子镀;CrSiN薄膜;Cr应力缓和层;内部应力;膜基结合强度

Abstract:

Keywords:

基金项目(Foundation): 重庆市科技攻关计划项目(CSTC,2008AC4017CSTC,2009AB6127)

作者(Author): 聂朝胤,安藤彰朗,潘婧,贾晓芳

DOI: 10.13289/j.issn.1009-6264.2010.10.028

参考文献(References)：

• [1]Gun Y H,Cheng H H.Improvement of fatigue life of electrical discharge machined AISI D2 tool steel by TiN film[J].Materials Science and Engineering A,2001,318:155-162.
• [2]Berg G,Friedrich C,Broszeit E,et al.A study of the corrosion behaviour and protective quality of sputtered chromium nitride films[J].Surf CoatTechnol,1996,86-87:184-191.
• [3]Diserens M,Patscheider J,Lévy F.Mechanical properties and oxidation resistance of nanocomposite TiN-SiNx physical-vapor-deposited thin films[J].Surf Coat Technol,1999,120-121:158-165.
• [4]Vaz F,Rebouta L,Goudeau P,et al.Characterisation of Ti1-xSixNy nanocomposite films[J].Surf Coat Technol,2000,131-134:307-313.
• [5]Zhang G,Wang L,Wang S C,et al.Stucture and mechanical properties of reactive sputtering CrSiN films[J].Applied Surface Science,2009,255:4425-4429.
• [6]Nie C Y,Ando A,Watanabe H,et al.Mechanical properties of Cr-Si-N coatings prepared by arc ion plating method and influence of bias voltage onthem[J].The Surface Finishing Society of Japan,2004,55:286-291.
• [7]聂朝胤,安藤彰朗,卢春灿,等.Ti掺杂及Ti应力缓和层对类金刚石薄膜附着力的影响[J].功能材料,2009,40(2):226-229.Nie C Y,Ando A,Lu C C,et al.The effect of Ti-doping and stress relaxation layer on adhesion strength of DLC thin film[J].Journal of FunctionalMaterials,2009,40(2):226-229.
• [8]Benkahoul M,Robin P,Gujrathi S C,et al.Microstructure and mechanical properties of Cr-Si-N coatings prepared by pulsed reactive dualmagnetron sputtering[J].Surf Coat Technol,2008,202:3975-3980.
• [9]Mercs D,Briois P,Demange V,et al.Influence of the addition of silicon on the structure and properties of chromium nitride coatings deposited byreactive magnetron sputtering assisted by RF plasmas[J].Surf Coat Technol,2007,201:6970-6976.
• [10]Noyan I C,Cohen J B.Residual Stress Measurements by diffraction and Interpretation[M].Springer-Verlag,New York,1987.

文章评论(Comment)：