贾书君,刘清友,刘明辉,高洪刚

• 1:中国钢研科技集团公司
• 2:本溪钢铁集团公司

摘要(Abstract)：

采用热模拟试验研究了两相区退火温度对TRIP590钢组织和性能的影响。结果表明:随着两相区退火温度的升高,铁素体体积分数先减少后增加,铁素体平均晶粒尺寸在整个实验温度范围内随着退火温度的升高一直减小;780～860℃范围退火时,残留奥氏体量和残留奥氏体富碳量都在820℃附近出现一个低谷,温度低于或高于820℃,残留奥氏体含量和残留奥氏体富碳量都增加,860℃退火时,残奥量和富碳量都最大;两相区退火温度的变化对抗拉强度基本影响不大,屈服强度随退火温度的变化略有增加,伸长率在820℃出现一个低谷,退火温度低于820℃时,伸长率随退火温度升高而降低,退火温度高于820℃时,伸长率随温度升高而升高,860℃退火时,伸长率达到最大值23%。

关键词(KeyWords)： 退火温度;多边形铁素体;残留奥氏体;富碳量;伸长率

Abstract:

Keywords:

基金项目(Foundation):

作者(Author): 贾书君,刘清友,刘明辉,高洪刚

DOI: 10.13289/j.issn.1009-6264.2013.06.023

参考文献(References)：

• [1]姚贵升.塑性变形诱导相变钢TRIP钢的性能和应用[J].汽车工艺与材料,2006(9):13-18.YAO Gui-sheng.Properties and application of TRIP steel[J].Automobile Technology&Material,2006(9):13-18.
• [2]Li Y X,Lin Z Q,Jiang A Q,et al.Use of high strength steel sheet for lightweight and crash worthy car body[J].Materials and Design,2003,24(3):77-178.
• [3]Sakuma Y,Matsumura O,Akisue O.Influence of C content and annealing temperature on microstructure and mechanical properties of 400℃transformed steel containing retained austenite[J].ISIJ Int,1991,31(11):1348-1353.
• [4]Eberle K,Cantinieaux P,Harlet Ph.Newt thermomechanical strategy for production of high strengh low alloyed multiphase steel showing transformationinduced plasticity effect[J].Ironmaking and Steelmaking,1999,26(3):176-.180.
• [5]Chang Gil Lee,Sung-joon Kim,Tae-ho Lee,et al.Effects of volume fraction and stability of retained austenite on formability in 0.1C-1.55Si-1.5Mn-0.5CuTRIP-aided cold-rolled steel sheet[J].Materials Science and Engineering,2004,371(1-2):16-23.
• [6]JING Cai-nian,WANG Zuo-cheng,HAN Fu-tao.Research progress of the influenceing factors on transformation induced plasticity[J].Metal HeatTreatment,2005,30(2):26-30.

文章评论(Comment)：