微弧氧化处理LD10铝合金的疲劳特性Fatigue properties of LD10 aluminium alloy with micro-arc oxidation coatings
梁戈,张亚娟,林敏
摘要(Abstract):
利用旋转弯曲疲劳试验机研究了三种膜厚(10μm、15μm、20μm)的微弧氧化处理LD10铝合金的疲劳性能;采用SEM观察微弧氧化试样的表面、截面以及断口形貌;利用XRD分析微弧氧化试样的表面相组成和表面残余应力。结果表明:微弧氧化膜层由AlSi0.5O2.5非晶相组成,膜层中的微裂纹起源于放电通道(微孔),终止在通道附近区域;膜层附近基体中存在残余拉应力,促使疲劳裂纹在此形成和扩展,导致10μm、15μm、20μm三种膜厚的微弧氧化处理铝合金的疲劳寿命分别下降了63%、75%和65%,疲劳极限分别下降了9.5%、7.9%和9.9%。
关键词(KeyWords): 微弧氧化;LD10铝合金;弯曲疲劳;残余应力
基金项目(Foundation): 西安航空制动科技有限公司项目
作者(Author): 梁戈,张亚娟,林敏
DOI: 10.13289/j.issn.1009-6264.2010.02.010
参考文献(References):
- [1]Niea X,Meletisa E I,Jianga J C,et al.Abrasive wear/corrosion properties and TEManalysis of Al2O3coatings fabricated using plasma electrolysis[J].Surface and Coatings Technology,2002,149(2-3):245-251.
- [2]Rajasekaran B,Ganesh Sundara Raman S,Joshi S V,et al.Effect of microarc oxidised layer thickness on plain fatigue and fretting fatigue behaviourof Al-Mg-Si alloy[J].International Journal of Fatigue,2008,30(7):1259-1266.
- [3]Lonyuk B,Apachitei I,Duszczyk J.The effect of oxide coatings on fatigue properties of 7475-T6 aluminium alloy[J].Surface and CoatingsTechnology,2007,201(21):8688-8694.
- [4]Asquith D T,et al.Effect of combined shot-peening and PEO treatment on fatigue life of2024 Al alloy[J].Thin Solid Films,2006,515(3):1187-1191.
- [5]Duan H,Yan C,Wang F.Growth process of plasma electrolytic oxidation films ormed on magnesium alloy AZ91D in silicate solution[J].Electrochimica Acta,2007,52(15):5002-5009.
- [6]Yerokhin A L,Nie X,Leyland A,et al.Plasma electrolysis for surface engineering[J].Surface and Coatings Technology,1999,122(2-3):73-93.
- [7]Khan R HU,Yerokhin A L,Pilkington T,et al.Residual stresses in plasma electrolytic oxidation coatings on Al alloy produced by pulsed unipolarcurrent[J].Surface and Coatings Technology,2005,200(5-6):1580-1586.
- [8]林吉忠,等.金属的缺陷、载荷与疲劳[M].北京:中国铁路出版社,1993:65.
- [9]Yerokhin A L,Shatrov A,Samsonov V,et al.Fatigue properties of keronite coatings on a magnesium alloy[J].Surface and Coatings Technology,2004,182(1):78-84.
- [10]Hanvock P,Hurst R C.Advances in Corrosion Science and Technology[M].New York:Plenum Press,1974.
- [11]李美栓,等.氧化膜应力研究进展[J].腐蚀科学与防护技术,1999,11(5):300-305.LI Mei-shuan,et al.A review on studies of lnternal stress in oxide scales[J].Corrosion Science and Protection Technology,1999,11(5):300-305.
- [12]邵淑英,等.薄膜应力研究[J].激光与光电子学进展,2005,42(1):22-27.SHAO Shu-ying,et al.A review of stress in thin film[J].Laser and Optronics Progress,2005,42(1):22-27.
文章评论(Comment):
|
||||||||||||||||||
|
||||||||||||||||||